Baseline Systems FlowStation User Manual
Page 11
FlowStation Quick Start Guide
STEP 9 – Connect the BaseStation 3200s to the FlowStation
When your FlowStation is powered up and connected to the network, you need to connect your
irrigation controllers to the FlowStation.
1. Get the IP Address from the FlowStation.
a. On the FlowStation, press the System Setup button.
b. Press the button to select the Network Setup option, and then press the OK button.
The Network Setup menu displays.
c.
Press the button to select the IP Info option, and then press the OK button. The IP
Info screen displays.
d. Find the IP address of the FlowStation in the IP ADDR field, and then write it down.
2. On a BaseStation 3200 irrigation controller that you want to connect to the FlowStation, turn
the dial to the Network position.
3. Press the Next button to highlight the Flow Station Setup option.
4. Press the Enter button. The Network screen
displays.
5. In the Flow Station Control field, press the +
button to change the setting to True.
6. Press the Next button to move to the first cell
of the Flow Station IP field.
7. Press the + button to change the number to
match the first group of numbers in the IP
address of the FlowStation.
Note: Press and hold the + button or the –
button to rapidly increase or decrease the number in the field.
8. Complete the IP address by pressing the Next button to move to the next cell of the Flow
Station IP field, and then pressing the + button to change the number.
9. Repeat steps 2 through 8 on each BaseStation 3200 irrigation controller that you want to
connect to the FlowStation.
Note: The connection between the controller and the FlowStation is not complete until you
assign the controller on the FlowStation. Refer to Assigning Controllers to the Shared Flow
Group in the FlowStation User Manual.
Page 7