Baseline Systems Ethernet Radio - Manual (Page 2)

BL-ER-P Ethernet Radio Unit for Pedestal
Installation Guide
1-866-294-5847
Rev 8.19.2014
www.baselinesystems.com
Prepare the Mounting Location for the Antenna Riser
1. Open and remove the front door on the lower part of the pedestal.
2. On the inside left wall of the pedestal, remove the nuts from the bolts that secure the cover
to the outside wall. Set the nuts aside to be replaced in a later step.
3. Remove the bolts that are holding the
cover on the outside wall. Set the
bolts aside to be replaced in a later
step.
4. Remove the cover from the outside
wall, making sure that the gasket stays
in place.
5. On the inside left wall of the pedestal,
note the hole that is covered by the
gasket.
6. On the outside left wall of the
pedestal, find the location of the hole
and use a sharp hobby knife to
remove the gasket material that is
covering the hole.
Note: This opening is used to route the
antenna cable inside the pedestal in
order to connect it to the Ethernet radio
unit. Make the hole large enough to pass
the cable through, but small enough to
maintain the seal.
Page 2