Baseline Systems BaseStation 3200 in Pedestal - Manual (Page 4)

BL-3200WF-P Wi-Fi Module for Pedestal
Installation Guide
1-866-294-5847
Rev 10.9.2014
www.baselinesystems.com
Install the Wi-Fi Module
1. Power down the controller.
2. Align the holes on the Wi-Fi module mounting
plate with the standoffs to the left of the control
board. Use the screws provided to securely
attach the module inside the pedestal.
3. If necessary, carefully turn the Wi-Fi module in
the mounting bracket so the indicator lights are
visible.
4. Inspect the cable coming from the bottom of
the Wi-Fi module. A label identifies the end of
the cable that is plugged into the Wi-Fi module.
If you ever need to disconnect or replace this
cable, make sure to plug the labeled end into
the Wi-Fi module. This cable supplies power over
Ethernet, and it must be plugged in correctly or
the irrigation controller can be damaged.
5. Notice that the cable coming from the bottom
of the Wi-Fi module splits in two. The thin cable
with the white connector is the power cable.
The thicker cable is Ethernet.
6. Inspect the power cord to ensure that it is not
wrapped around the Ethernet cable. If it is,
unwrap it.
Continued 
Page 4