Basestation 1000 instructions – Baseline Systems BaseStation 1000 User Manual
Page 8
Baseline Cell Modem Installation and User Guide
13. Reconnect the orange power connector to the board in order to restore power to the
controller.
14. Reposition the black plastic cover over the controller PCA board, and then secure it with the
two screws.
15. Close the enclosure door, and then restart the controller.
BaseStation 1000: Press the RUN button.
BaseStation 3200: Turn the dial to the RUN position.
Step 2 – Check Your Firmware Version & Update if
Necessary
BaseStation 1000 Instructions
BaseStation 1000 controllers running firmware version 1.4 and higher have integrated support for
cell modem communication. If your controller is running firmware version 1.3 or lower, you will
need to download a firmware update onto a USB drive from the Baseline web site.
To check the version of firmware on your BaseStation 1000 controller
1. On the BaseStation 1000, press the System
Setup button. The System Setup menu
displays.
2. Press the button to highlight the
Firmware Update option, and then press
the OK button to select it. The Firmware
Update menu displays.
3. The USB Update option should be
highlighted. If it is not highlighted, press the button to highlight it, and then press the OK
button to select it.
The USB Update screen displays the current firmware version at the top. If your controller is
running firmware version 1.3 or lower, you will need to download a firmware update onto a
USB drive from the Baseline web site, and then install it on your controller.
To update the BaseStation 1000 firmware from the Baseline web site
You will need a computer with a USB port. This computer must have access to the Internet. You
also need a USB (thumb) drive. You download the firmware from the Baseline web site to the USB
drive. Then, you take the USB drive to the controller and install the update.
1. Go to the Baseline web site at the following URL:
2. On the home page, click Support.
Page 4