Baseline Systems BaseStation 1000 - Manual (Page 14)

BaseStation 1000 Quick Start Guide
Page 8
Interval
Set up a custom day interval.
Smart Interval
Set up the intervals for each half month.
Set Start Times
Each active program must have at least one start time. Programs that have no start
times will not run.
Moisture Start
Set up a moisture start condition for a program that will cause the program to start based on
a specified soil moisture reading.
E. Switch Start
Set up a start condition for a program based on the state of an event switch.
Temperature Start
Set up a start condition for a program that will cause the program to start based on a
specified temperature sensor reading.
Seasonal Adjust
Adjust your entire system either up or down if your area is experiencing unusually wet or dry
weather.
Soak Cycles
Set up the cycle time and soak time (“soak cycles”) for your zones to ensure that water soaks into
the soil instead of being wasted.
Water Windows
Set up when watering will or will not be allowed.
Zones at One Time
Depending on the amount of water available from your water source and the electrical limits, your
system might be able to operate more than one zone at a time.
Enabled/Disabled
By default, all BaseStation 1000 programs are enabled, which means that those programs will run
when devices are connected and configured for the programs. If you do not want certain programs
to run, you can disable them. You can re-enable a disabled program as needed.
Setup Prg. Pause
Set up a condition that will cause a running program to pause when that condition occurs. The
following pause conditions are available: