Baseline Systems BaseStation 1000 - Manual (Page 13)

BaseStation 1000 Quick Start Guide
Page 7
Zone Status
Displays the Zone Status report
Program Status
Displays the Program Status report
Flow & MV/Pump Status
Displays the Flow and MV/Pump Status report
Running Zones
Displays the zones that are currently running
View Messages
Displays any messages generated by the controller
Rain Delay
Enables you to set up a rain delay that stops all watering for a specified number of days
Event Days
Enables you to set up event days and times that will pause all watering
System Status
Displays the System Status screen
Program Setup Menu
Zone Runtimes
Use this option to configure the total amount of time that each zone can run.
Setup Prg. Start Menu
A program is not active until you select a start condition for it. Use the options under this menu to
set up the start conditions for your program.
Day & Time Start Menu
If there is no start time, then the program is considered to be OFF or disabled and no
watering will be allowed on the zones of that program.
Set Start Days
A variety of start day options are available. Of those options, the following have a
specialized configuration screen:
Set Weekdays
Choose the weekdays when watering is allowed.