B&G Network Wind - Manual (Page 13)

ADJUSTING THE WIND SENSOR OFFSET
If the value calculated is positive, the wind sensor is
misaligned to Port. To correct this the analogue pointer must
be offset clockwise (towards starboard) by the value
calculated. Use the ¿ key (up) to change the value displayed
on the LCD.
If the value is negative, the wind sensor is misaligned to
Starboard. To correct this the analogue pointer must be offset
anti-clockwise (to port) by the value calculated. Use the À key
(down) to change the value displayed on the LCD.
Press SETUP key 3
times to display OF,
OFfset value. Press ENTER key to
display current value.
The display flashes.
Factory set to zero. Use ¿ or À key to
adjust the value.
¿
= clockwise
À = anti-clockwise.
Press ENTER key to
memorise the new
value. After 30 secs
the display will revert to
previously selected
display.
HB-0502-03 13