B&G Zeus2 12 - Manual (Page 11)

| 5 Hardware installation | Zeus2 Installation Manual
Display installation
Bracket mounting
Place the bracket in the desired mounting location, and use a pencil or permanent marker to
mark drilling locations.
 Note:
ensure that the chosen location has enough height to accomodate the display fi tted in
the bracket, and allows tilting of the display. Also adequate space is required on both sides to
allow tightening and loosening of the knobs.
Use fasteners suited to the mounting surface material. If the material is too thin for self
tappers, reinforce it, or mount bracket with machine screws and large washers. Use only 304
or 316 stainless steel fasteners. Mark the screw locations using bracket as template, and drill
pilot holes.
Screw down the bracket.
Mount the display to the bracket using the knobs. Hand tighten only. The ratchet teeth in
the bracket and display case ensure a positive grip and prevent the unit changing from the
desired angle.