Mounting to the ars (amico rail system) – Amico AHM Monitor Arms (Adjustable Height) User Manual
Page 11
www.amico.com
8
(Figure 1)
ARS Adapter
Tab on ARS
ARS Rail
AHM Arm
AHM Horizontal
Adapter
ARS Adapter
installed
ARS Rail
(Figure 2)
Mounting on a headwall
(Figure 3)
AHM Arm
AHM Horizontal Adapter
ARS Rail
Support Block
Mounting on a single ARS
WARNING:
Never attempt to mount or remove the arm from the rail when a monitor is installed
WARNING:
Your AHM is pre-assembled with the ARS adapter(s), ensure that the ARS adapter is sitting inside the
rail properly before installing a monitor.
DO NOT install the AHM with just one adapter.
Both ARS adapters must be
installed.
Only exception is if your unit is to be installed on a single ARS Rail.
In this case, ensure the support block is
sitting flush against the wall.
(Following steps apply only to units to be mounted on a headwall)
1. Determine the best location to install the AHM arm, then remove the two screws at the bottom of the AHM
horizontal adapter to free one of the ARS adapters. Install the freed ARS adapter into the bottom rail by angling the
upper lip into the inside lip of the ARS rail, hold the tab on the ARS and push the ARS adapter into the rail.
Once
secure, release the tab
(Figure 1)
.
2. Mount the AHM arm by angling the top ARS adapter attached to the ARS horizontal adapter in the same way as step
1, ensuring the two holes on the bottom ARS adapter can be seen through the AHM horizontal adapter, secure the
two Philips screws from the bottom of the AHM horizontal adapter.
(Figure 2)
(Following step applies only to units to be mounted on a single rail)
3. Install the AHM arm by installing the ARS adapter attached to the AHM arm by angling the upper lip into the inside
lip of the ARS rail, hold the tab on the ARS and push the ARS adapter into the rail.
Once it is secure, release the tab
ensure the support block is sitting flush and firmly against the wall.
(Figure 3).
Mounting to the ARS (Amico Rail System)