Great Plains TL350 Operator Manual - Manual (Page 26)

26 Simba TL
605-039M-ENG
2013-02-27
5.7 Operator Support
If you have a problem, please contact your
dealer. They will endeavour to solve any
problems which may occur and provide you
with support at all times.
In order to enable your dealer to deal with
problems as quickly as possible, it helps if
you can provide them with the following data.
Always state the:
 Customer Number
 Name and Address
 Machine Model
 Serial Number of Machine
 Date of Purchase and Operating
Hours
 Type of Problem
5.8 Maintenance
Intervals
Apart from daily maintenance, the
maintenance intervals are based on the
number of operating hours and time data.
Keep a record of your operating hours to
ensure that the specified maintenance
intervals are adhered to as closely as
possible.
Never use a machine that is due for
maintenance. Ensure that all deficiencies
found during regular checks are remedied
immediately.
On a new machine tighten all nuts and bolts
after 5 hours work and again after 15 hours.
This also applies to parts that have been
moved or replaced. After the initial 15 hours
of work a once a week check should be
sufficient depending on daily work rates.
Avoid sharp-edged and pointed
parts (disc blades, etc.) when
working on the machine.
Place the machine on suitable
s u p p o r t s w h e n w o r k i n g
underneath! Do not work under a
machine which is not supported!
5. Servicing and Maintenance