Great Plains 3N-40P - Manual (Page 3)

6/1/2004 197-008M
Great Plains Mfg., Inc.
3 Installation Instructions
Refer to Figure 5
10. Drill a 9/16" hole from the outside of the end
panel.
Refer to Figure 6
11. Reinstall the gusset using the 1/4" x 1" bolts
and 1/4" flange nuts and 1/2" x 1 1/4" bolts,
1/2" lock washers and 1/2" nuts. Repeat this
process on each end of the trays.
Refer to Figure 7
12. Remove the box partition top nut (1) on front
side of box and install the partition upper pad
(2). Reinstall the nut leaving loose. Level the
pad and tighten the nut.
Figure 5
Drilling 9/16" Hole
22537
Figure 6
Gusset
22538
Figure 7
Partition Upper Pad
22543