Great Plains 3N-40P - Manual

© Copyright 2004 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
197-008M
No-Till Drill
Box Support Update
• 40P and 40F
General Information
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
These instructions explain how to install the Box
Support Update Kit.
These instructions apply to:
197-006A 3N-40 Box Support Update Kit
197-007A 3N-40P Box Support Update Kit
Manual Update
Refer to the drill operator’s manual for detailed in-
formation on safely operating, adjusting,
troubleshooting and maintaining the drill. Refer to
the parts manual for part identification.
196-286M Operator’s Manual
196-286M Parts Manual
196-359M Operator’s Manual
196-359M Parts Manual
4/6/2004
Before You Start
Page 4 is a detailed listing of parts included in the
Box Support Update Kit package. Use this list to
inventory parts received.
Tools Required
• electric drill
• basic hand tools
Definitions
Right-hand and left-hand as used in this manual
are determined by facing the direction the ma-
chine will travel while in use unless otherwise
stated.
Assembly Instructions
Refer to Figure 1
1. Remove two bolts from end of tray on rear side
of box.
2. Install hole template with bolts removed in
step one and tighten.
3. Drill three 5/16" holes using the template as a
guide.
4. Remove template and install five 1/4" x 5/8"
bolts and 1/4" flange nuts reusing two nuts
and bolts removed in steps one and three nuts
and bolts supplied in kit.
5. Repeat this process on both ends of each tray
on the back side of each box.
Template
Figure 1
Using template
22533