Great Plains TCN5313 Predelivery Manual - Manual (Page 18)

14 TCN5107-5313 Great Plains Manufacturing, Inc.
566-170Q 03/17/2014
Install Rear Hitch (optional)
Note: The rear tow hitch will be shipped with big compo-
nents banded together and bolts will be in a box.
Carefully un-band the components.
Refer to Figure 16
66. Attach rear hitch trusses
to rear of hitch trusses with
3/4 x 2 1/2 hex bolts , 3/4 lock washers and 3/4 nuts.
Attach middle of rear hitch trusses to tubes on center
frame with 3/4 x 4 1/32 x 7 1/2 u-bolts
, 3/4 lock
washers and 3/4 nuts.
67. Attach 56” cross arm to bottom side of rear hitch
truss plates with 5/8 x 3 1/32 x 4 1/2 u-bolts , secure
with 5/8 lock washers and 5/8 nuts.
Note: Do not tighten any bolts until every thing is installed.
Note: The bolt on sleeve assembly with rigid or flex slide
may be fastened using 5/8 x 3 1/32 x 4 1/2 u-bolt ,
secure with 5/8 lock washers and 5/8 nuts.
Note: Tighten all bolts to specs, See “Torque Values
Chart” on page 15.
Note: If machine is equipped with optional rear hitch acces-
sory kit may be installed as shown in “Parts Manual”.
Note: Route hoses and light harness along hitch and frame
with hose clamps and hose wraps, provided.
Note: Be sure hoses and light harness is fastened securely
so they don’t drag or get pinched.
Completing Setup
68. If the Turbo-Chisel is equipped with an optional finish-
ing attachment, refer to “Parts Manual” for parts break-
down and layout section of “Operator’s Manual” for
proper placement.
If machine is equipped with a rear attachment, be sure you install
the rear jack stand, see “Parts Manual” Rear Jack Stand, so
machine doesn’t tip backwards when unhooking machine from
tractor.
69. Once the options are installed, fold the Turbo-Chisel to
check for clearance and interferences. Slowly fold
Turbo-Chisel while watching that hoses and wiring har-
nesses do not become pinched or kinked while watch-
ing for interferences.
Note: Double check that all bolts are tightened to specs,
See “Torque Values Chart” on page 15.Consult the
“Operator’s Manual”, for the first time field adjust-
ments before going to the field.
Figure 16
Rear Hitch
42049
1
2
5
3
4
6
6
1
2
3
4
5
6
5