Great Plains TCN5313 Predelivery Manual - Manual (Page 17)

Great Plains Manufacturing, Inc. Assembly 13
03/17/2014 566-170Q
569-190S Shank
Note: The 569-190S shank mount assemblies will be
shipped pre assembled in proper location.
Refer to Figure 13
55. Attach the shank assemblies
to shank mounts
with 3/4 x 4 hex bolts , (top hole) 3/4 lock washers
and 3/4 nuts. Install 5/8 x 4 hex bolt , 5/8 lock
washer and 5/8 nut in bottom hole.
56. Tighten all bolts to specs, See “Torque Values Chart”
on page 15.
569-196S Shank
Note: The 569-196S shank mount assemblies will be
shipped in a wooden box. See machine layouts in
Appendix for proper shank placement.
Refer to Figure 14
57. Install the shank mount assemblies
to the rear side
of tubes. Install front mount bracket on front of
tubes, align holes, secure with 3/4 x 2 1/2 hex bolts ,
3/4 lock washers and 3/4 nuts. Slide these two parts
over frame tube in proper location.
58. Tighten all bolts to specs, See “Torque Values
Chart” on page 15.
Depth Gauge
Refer to Figure 15
59. Install the link mount
to the center gang bar with 1/
2 x 3 1/32 x 7 1/4 u-bolt , 1/2 lock washers and 1/2
nuts.
60. Install leveling weldment to the center gang mount
with 1/2 x 5 1/32 x 4 1/2 u-bolts , 1/2 lock washers
and 1/2 nuts.
61. Slide the depth gauge pointer over the leveling
weldment bolt, secure with 1/2 lock nut.
62. Align one set of holes in the two links , one on each
side of the depth gauge pointer hole 5, secure with 1/
2 x 1 1/2 bolt
and 1/2 lock nut.
63. Attach the other end of the links , one on each side
of the hole in the link mount with 1/2 x 1 1/2 bolt
and 1/2 lock nut.
64. Tighten all u-bolts to specs, See “Torque Values
Chart” on page 15. Tighten the three lock nuts up
snug, but be sure the links will pivot.
65. Clean the surface where TC depth coulter decal
goes and peel backing off of decal and fasten decal
on plate. Firmly press decal to get all air bubbles out
Figure 13
569-190S Shank
42047
1
3
2
4
1 2
3
4
Figure 14
596-196S Shank
42048
1
3
2
1
2
3
Figure 15
Depth Gauge
41668
4
7
8
1
5
2
3
9
6
1
2
3
4
5
7
8
7
1 8
9