Great Plains Vantage I & Zone Coulter Fertilizer Coulters - Manual (Page 11)

3/9/2005 204-376M
9 Adjustments
Side To Side Adjustment
Refer to Figure 4
1. Remove the 1/2" hex flange nut (1), and flat
washer (4) holding the tine (9) to the back arm
(6).
2. Center the tine behind the coulter blade by
adding or removing the 3/16" rectangular
spacer washers (10) which fit between the
back arm (6) and the fertilizer tine clip (8).
Store unused spacer washers on the oppo-
site side of the back arm.
3. If a finer adjustment is necessary to center
the tine behind the coulter blade, place a 1/2"
flat washer (4) between the front arm (7) and
back arm (6) to shim them apart. Store un-
used washers on the outside of the back arm
under the
1/2" flange nuts. Once the tine is centered be-
hind the coulter blade, make sure it is straight
with the blade and adjust the side to side ro-
tation of the tine
Side To Side Rotation
Refer to Figure 5
1. The fertilizer tine must be straight with the
coulter blade as well as centered behind it. To
alter the side to side rotation of the tine, first
remove the hex flange nuts (1) holding the
back arm (6) to the front arm (7).
2. To rotate the bottom of the tine counterclock-
wise, place one 1/2" flat washer (4), between
the front arm (7) and back arm (6) on the up-
per hex flange bolt (2), and retighten the hex
flange nuts. Extra washers are stored behind
the hex flange nuts.
3. To rotate the bottom of the tine clockwise,
place one 1/2" flat washer (4), between the
frontarm (7) and back arm (6) on the lower
hex flange bolt (2), and retighten the hex
flange nuts.
Figure 4
Side to Side Adjustment
Figure 5
Side to Side Rotation
13252
13253
!
WARNING
Great Plains denies any responsibility for damage caused to seed due to the improper application of liquid fertilizer or chemical.
It is the sole responsibility of the user of liquid fertilizer or chemical for any damage incurred.