Great Plains EWNT10 - Manual (Page 5)

Assembly
0 5/3/96 Great Plains Mfg., Inc. 7’ & 10’ End Wheel No-Till Clutch Linkage 152-156M
Before You Start
Read and understand the owners manual for your
Clutch Linkage Update Kit. A basic understanding of
how the kit works will aid in the assembly, setup and op-
eration of your drill.
Before attempting to assemble the Clutch Linkage Up-
date Kit, use the following as a checklist. Having all the
needed parts and equipment readily at hand will speed
up your assembly task and will make the job as safe as
possible.
❑
Check for all kit components and hardware.
❑
If a bolt, pin or other component has been removed,
or if you are unsure about where it is used, refer to
the parts section of this manual to identify it.
Old 7’ End Wheel No-Till
Clutch Linkage Disassembly
Refer to Figure 2-1:
Start by disassembling the clutch linkage. Unbolt the
clutch shaft from the shaft supports, but leave the clutch
assembly together. Refer to Figure 2-1 for what will not
be used. After all the linkage is disassembled, torch off
the clutch mounting tab and the clutch lever bracket from
the hanger sub-weldment.
13802
Old 7’ End Wheel No-Till Disassembly
Figure 2-1
Parts Not Used
Figure 2-2
13803