Great Plains 6548 Series VII Field Cultivator-Floating Hitch Operator Manual - Manual (Page 26)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc.
Series VII 6330-6548 Field Cultivator, Floating Hitch 560-205M 11/22/2005
24
Center Wing Stop and Outside Wing Stop Assembly
U-bolt the center wing stop (1) to the
second bar from the rear on the center frame as
shown in Figure 13. Use 5/8 x 4 x 4 1/4 u-
bolts (2) with lock washers and hex nuts.
Center the wing stop from side to side. Insert
the 1/2 x 4 1/2 transport lock quick pins (3) in
the holders on the wing stop.
On Model 6541-6548, attach the center
wheel alignment stub (4) to the center of the
wing stop using 5/8 x 2 1/2 x 3 1/2 u-bolts (5),
lock washers and hex nuts. U-bolt the wing
wheel alignment stub (6) to the inside wing
frame using 1/2 x 3 x 5 u-bolts (7), lock
washers and hex nuts. See shank layout for
proper location for your model.
On Models 6537-6548, u-bolt the wing
lock mount (8) on the inside wing with 1/2 x 3
x 5 u-bolts (9). U-bolt the wing lock “T”
bracket (13) on the outside wing with the same
1/2 x 3 x 5 u-bolt (9). Refer to the shank layout
for your particular model for the exact location
of the wing lock mount and lock “T” bracket.
Use lock washers and hex nuts on these u-bolts
(Note: On models 6537 and 6541 the T-
Bracket uses 5/8 x 4 1/32 x 4 1/4 u-bolts).
Bolt the wing latch (10) to the wing lock
mount (8) with a 3/4 x 4 1/2 bolt (11). Slide a
3/4 flat washer (12) between the latch and the
mount on each side to take out the slop. Use a
3/4” lock nut but do not torque down. The
latch must move freely.
Figure 13