Great Plains 6548 Series VII Field Cultivator-Floating Hitch Operator Manual - Manual (Page 23)

Great Plains Mfg., Inc. Table of Contents ►
Section 1: Assembly
1/22/2005 Series VII 6330-6548 Field Cultivator, Floating Hitch 560-205M
21
Wing Caster Wheel Linkage Assembly
Insert the wing level bar (1) through
the hole in the rocker fold bracket as shown in
Figure 8. Attach the wing level bar (1) to the
wheel bracket with a 1 x 3 3/8 usable clevis
pin (2), 1” flat washers, 1” machine washer
and 3/16 x 2 cotter pin. Slide the leveling link
(3) over the leveling link mounting tube and
attach with a 1 x 6 special thread GR 8 hex
bolt (4) and nylon lock nut, do not torque.
Bolt the gauge wheel level bar (1) to the
turnbuckle assembly (5) through the leveling
link (3) as shown. Use a 1 x 6 Gr.8 special
thread hex bolt (4) and nylon lock nut. Do not
torgue as before.
U-bolt the gauge wheel arm mounts (6
& 7) to the brace bar with three 3/4 x 3 x 5 1/2
u-bolts (8), lock washers and hex nuts. Insert
the bottom gauge wheel arm (10) and secure
with 1 x 5 1/2 special hex bolts (9) and nylon
lock nuts, do not torque. Attach the top gauge
wheel arm (11) with the same 1 x 5 1/2 special
hex bolt and nylon lock nut, do not torque.
Connect the turnbuckle to the bottom arm with
a 1 x 4 clevis pin (12), machine washer and
3/16 x 2 cotter pin. See Caster Wheel
Assembly, Section 3, in parts manual, for
caster wheel exploded diagram.
Figure 8