Great Plains Yield-Pro Planter 1.6 Hopper - Manual (Page 4)

4 Great Plains Manufacturing, Inc. Front Page Part Lists YP 1.6 Bu Hopper Enhancement
403-612M Front Page Part Lists 08/16/2011
Install New Left Hand Hopper
Refer to Figure 4
The right hand and left hand opener mounts are offset.
Be sure the placement is correct for right/left offset orien-
tation.
The left hand mount has a 3/8in bolt that is reused
(from the existing assembly). It attaches the idler spool
on the bracket.
Install Hopper Support Mount
10. Select:
1 403-564H LH HOPPER MOUNT WLDMNT
1 802-017C HHCS 3/8-16X1 GR5
1 802-323C HHCS 1/2-13X6 1/2 GR5
1 803-169C HEX FLG LOCK 1/2-13 PLT
2 803-209C FLANGE LOCK 3/8-16 PLT
Secure mount to opener arm bracket using bolt
and nut
.
Just below this hardware insert ildler spacer
tube
, idler spool , and secure with saved bolt
and flange lock . On opposite side insert
bolt and flange lock . Tighten.
Place Hopper on Mount
11. Select one each:
1 403-595K HOPPER ASSEMBLY LH
4 802-092C RHSNB 5/16-18X3/4 GR5
4 803-177C NUT HEX FLG TP LK 5/16-18ZNYCR
Place new 1.6 bu hopper on hopper mount
and adjoin bottom opening to seed hose. Secure
hopper to mount with four carriage bolts
and four
nuts .
Connect Meter Air Hose
12. Select one:
800-060C CABLE TIE .19X14.25 3DIA 50
Route the air hose through the top left hand corner
of the mount and reconnect it to the air inlet elbow
on the tube meter securing with the clamp saved
earlier. Secure the air hose to the tab mount
with
the cable tie .
Connect Blockage Monitor Wire
13. Select one:
800-112C CABLE TIE .19X7.25 1.75D 50
Route the blockage monitor cable through the hole
in the front of the mount
and reconnect to the
harness. Secure the cable to the mount with
cable tie through hole in the mount and
opener.
Figure 4
Left Hand Hopper
32233
U
D
F
B
L
R
16
17
18
19
20
15
14
23
31
24 25
32
21
21
23
14
18
19
20
21
19
20
25 24
23 21
18 21
15
31
32
15 14
31
32
16
99
16
17
14
14
17 98