Great Plains SS0300 Operator Manual - Manual (Page 21)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 17
09/19/2011 Table of Contents Index 596-224M
Coulter Spring
Refer to Figure 10
1. The coulter springs are preset at the factory to
between 9 7/8” to 10”. This is measured from the
inside surface of the coulter spring washer to the
inside surface of the coulter bushing.
Note: Adjusting the spring below 9 7/8” could cause prema-
ture part failure and void the warranty.
Berm Conditioner
Refer to Figure 11
1. The berm conditioner may be adjusted pulling up on
handle sliding to a different notch.
2. For maximum down pressure move handle towards
rear.
Figure 10
Coulter Spring Adjustment
21648
FigureSpacer:
FigureSpacer:
Figure 11
Berm Conditioner Adjustment
41864
FigureSpacer:
FigureSpacer: