Great Plains SS0300 Operator Manual - Manual (Page 17)

09/19/2011 Table of Contents Index 596-224M
Great Plains Manufacturing, Inc. Table of Contents Index 13
Preparation and Setup
This section helps you prepare your tractor and SS0300
Sub-Soiler for use, and covers tasks that need to be done
seasonally, or when the tractor/Sub-Soiler configuration
changes.
Before using the Sub-Soiler in the field, you must hitch it to
a suitable tractor, inspect systems and level the Sub-
Soiler. Before using the Sub-Soiler for the first time, and
periodically thereafter, certain adjustments and calibra-
tions are required.
Prior to Going to the Field Checklist
Complete this checklist before routine setup:
❑ Read and understand “Important Safety Informa-
tion” on page 5.
❑ Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
❑ Make sure your tractor horsepower matches the
implement you are pulling. This is important so the
implement can do the best possible job.
❑ Check that all grease fittings are in place and lubri-
cated. See “Lubrication” on page 22. The hubs will
come pre-greased and will not need greased at this
time.
❑ Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
“Safety Reflectors and Decals” on page 9.
❑ Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 25.