Great Plains ADC2350B Assembly Instructions - Manual (Page 2)

Great Plains Mfg., Inc.
2 Auger Carrier Update
166-255M 03/05/2009
Before You Start
Compatibility
Refer to Figure 2
Check the cart serial number plate against the table on
page 1. Verify that
the model is ADC2350B, and
the serial number is A1159T or lower.
Inventory
1. Make sure all parts are present.
Comprehension
2. Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
Note: Illustrations in this manual, based on the parts
manuals for this family of drills, may show
exploded views that are fully disassembled. Rely
on the instructions for required disassembly and
reassembly steps.
Pre-Assembly Preparation
Tools Required
• hoist with 300 pounds (150 kg) capacity at a height of
ten feet (3m), for supporting the dismounted auger
• updated cart Parts Manual (see page 1)
• basic hand tools, including:
9 ⁄
32
in / K / 7.2mm punch or drill.
Work Location
3. Clear the auger of any residual seed or fertilizer.
4. Move the air cart to a location with:
• adequate illumination,
• hoist access, and;
• a means of obtaining lower than normal depres-
sion of the inlet end of the auger (about
18in (46cm) below normal ground level), to
relieve as much tension as possible from the
auger balance springs; for example:
- a dock, with auger off right edge,
- a solid platform or blocks under right main tire,
- jack and supports for right side of frame.
Note: If the depression cannot be accomplished at the
hoist location, disconnect the springs (step 23 and
24), then move the cart to the hoist site.
Note: Once the old springs are disconnected, auger end
depression is no longer required. The new spring
anchor engages at zero spring extension.
Figure 2
ADC2350B Serial Number Plate
26428
U
D
F
B
L
R