Great Plains 2335SC Predelivery Manual - Manual (Page 12)

8 2112-2335SC Great Plains Manufacturing, Inc.
540-072Q 10/08/2013
2325-2335 Wings
Refer to Figure 6
14. Use fork truck or overhead hoist to move the wing assem-
bly closer to center section. Set wing assembly on
stands if available.
15. Remove 1x6 hex bolts and align holes in wing frame
assembly with holes in center frame and re-install 1x6 hex
bolts
, secure with 1 nylon insert lock nut. Bolts must be
installed so the head of the bolt is in the hex bolt stop.
Hinge bolts should be drawn down snug but do not torque
as wing needs to pivot freely.
16. Do not attach rod end of wing fold cylinders until system
has been purged of air, See “2325-2335 Purging Hydrau-
lic System” on page 10.
Attach Hose Clamps and Hose Wraps
Refer to Figure 7
17. When all the hoses are hooked up and tightened properly,
put hose clamps on hoses as shown.
18. Install hose wraps on hoses as needed.
Note: Be sure and get hoses and light wiring harness fastened
properly so they do not drag. Check to be sure there is
enough slack in hinge area when folding machine the
first time.
Figure 6
2325-2335 Wings
41407
2
1
2
U
D
F
B
L
R
1
2
2
Figure 7
Hose Clamps & Wraps
41583