Great Plains ADC1150 Operator Manual - Manual (Page 66)

64
Section 4 Adjustments
Model 1150 1995 - 1997 167-058M 7/28/10
Great Plains Mfg., Inc.
Raise the implement fully and check that the switch is
NOTE: The switch circuit is designed so that seed will
be metered if the switch is extended (off cam). Meter-
ing is stopped when the switch is compressed (on
cam). Meter will not shut off when the implement is
raised if cam clamp should come loose.
compressed, refer to Figure 4-25.
Metering Off Position
Figure 4-25
14550
Operating Checklist
✔ Check Reference
Safety Rules Page 1
Operating Instructions Page 37
Tire Pressure Page 86
Air Leaks, Lids Securely Latched Page 39
Page 41
Driver/Driven Gear Setting Page 46
Gearbox Shift Setting Page 46
Speed Change Orientation Page 46
Lubricate Drill as Needed Page 69
Check for Hydraulic Leaks Page 37
Page 39
Level the Implement Page 28
Page 60
Bleed Hydraulic Lines Page 24
Inspect Bin for Foreign Material Page 39
Rotate Hand Crank to be sure Meter Sys-
tem Turns Freely Page 46