Great Plains 3S-4000F Predelivery Manual - Manual (Page 8)

3S-4000
195-242Q 9/12/2009
6
The following headings are step-by-step instruc-
tions for assembling the 4000-3S drill. Begin with
“Tools Required” and “Pre-Assembly Checklist” to
make sure you have all necessary parts and
equipment. Follow each step to make the job as
quick and safe as possible and produce a properly
working machine.
The 4000-3S drill is shipped via flat bed truck. It is
the dealer’s responsibility to unload the new ma-
chine. Unload all equipment before beginning
assembly. Do not attempt any assembly work
while the 4000-3S drill is on the truck.
Tools Required
• Fork lift, overhead hoist, or loader
• General hand tools
Pre-Assembly Checklist
1. Before assembling, read and understand “Im-
portant Safety Information,” beginning on
page 1.
2. Have at least two people on hand while as-
sembling.
3. Make sure assembly area is level and free of
obstructions (preferably an open concrete ar-
ea).
4. Have all major components.
5. Have all fasteners and pins shipped with the
drill.
IMPORTANT: If a pre-assembled part or fas-
tener is temporarily removed, remember
where it goes. Keep the parts separated.
6. Have a copy of the parts manual on hand. If
unsure of proper placement or use of any part
or fastener, refer to the parts manual.
Assembly