Great Plains PH-20 Predelivery Manual - Manual (Page 7)

5
Section 1 Assembly
2/20/2006 PFH-15 and PFH-20 Precision Fertilizer Hitch 148-365Q
Great Plains Mfg., Inc.
Section 1
Assembly
The following headings are instructions for assembling the
hitch and its fertilizer options. Begin with Tools Required
and Pre-Assembly Checklist to make sure you have all
necessary parts and equipment, then proceed with as-
sembly. Complete sections as required; skip sections for
options not purchased with hitch.
The hitch is shipped via flat bed truck. It is the dealer’s re-
sponsibility to unload the new machine. Unload all equip-
ment before beginning assembly. Do not attempt any
assembly work while the hitch is on the truck.
Tools Required
•
Forklift or Hoist
•
General Hand Tools
•
Utility Knife
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of ob-
structions and overhead power lines (preferably an
open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with the drill.
6. Have a copy of the parts manual on hand. If unsure of
proper placement or use of any part or fastener, refer
to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
8. Check for proper tension and alignment on all drive
chains.
9. Check that all safety decals and reflectors are correct-
ly located and legible. Replace if improperly located or
damaged. Refer to Safety Decals, “Important Safety
Information” in the operator’s manual.
10. Inflate tires to recommended pressure as listed on the
Tire Inflation Chart on the “Appendix” on page 20.
Tighten wheel bolts as specified on Torque Values
Chart on the “Appendix” on page 20.
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.