Wheatheart Self-Propelled Auger Kit (Competitors Models) - Manual (Page 19)

W HEATHEART - S ELF -P ROPELLED A UGER K IT 3. A SSEMBLY
C OMPETITOR M ODELS 3.6. O VER -C ENTER D RIVE A SSEMBLY —S QUARE A XLES
30766 R0 19
Figure 3.5 Over-Center Assembly Positioning
3.6. OVER-CENTER DRIVE ASSEMBLY—SQUARE AXLES
1. Once the wheel is bolted to the hub, the over-center drive assembly can be
installed.
2. Position the axle cap of the over-center drive assembly squarely on the axle
tube as shown in Figure 3.6.
3. With the pinion gear flush with the ring gear (Figure 3.5), weld the axle cap to
the axle tube.
Figure 3.6 Over-Center Assembly
Positioning
Figure 3.7 Square Axle over-
Center for Competitor Models