Dymo LabelPoint 250 - Manual (Page 2)

3
About Your New Labelmaker
With your new DYMO LabelPOINT
™
250
labelmaker, you can create a wide variety of high-
quality, self-adhesive labels. You can choose to
print your labels in many different sizes and styles.
The labelmaker uses DYMO D1 tape cassettes in
widths of 6 mm (1/4”), 9 mm (3/8”), and 12 mm
(1/2”). Tape cassettes are also available in a wide
range of colors.
Visit www.dymo.com for information on obtaining
labels and accessories for your labelmaker.
Warranty Registration
Please complete the warranty registration card and
return it to the appropriate customer service
address within seven days. Visit www.dymo.com
for details.
Getting Started
Follow the instructions in this section to print your
first label.
Connecting the Power
The labelmaker is powered by standard batteries or
an AC power adapter. To save power, the
labelmaker will automatically turn off after two
minutes of inactivity.
Inserting the Batteries
The labelmaker uses six 1,5V AA batteries.
To insert the batteries
1. Remove the battery compartment cover. See
Figure 2.
Figure 2
2. Insert the batteries following the
polarity markings (+ and –).
3. Replace the battery compartment cover.
Remove the batteries if the labelmaker will
not be used for a long period of time.
Connecting the Power Adapter
An optional AC power adapter can also be used to
power the labelmaker. Connecting the AC adapter
to the labelmaker disconnects the batteries as a
power source.
To connect the power adapter
1. Plug the power adapter into the power connector
on the top, left side of the labelmaker.
2. Plug the other end of the power adapter into a
power outlet.
Make sure the labelmaker power is turned off
before you disconnect the power adapter from the
main power source. Otherwise, your most recent
memory settings will be lost.
Inserting the Tape Cassette
Your labelmaker comes with one tape cassette.
Visit www.dymo.com for information about
purchasing additional tape cassettes.
GB