ClearOne Ceiling Microphone Array - Manual (Page 5)

INSTALLATION MANUAL 2
Installation
PHYSICAL CHARACTERISTICS
Microphone Array Dimensions (Excluding Cables and Mounting)
Length: 3.3 in (8.38 cm)
Diameter: 1.5 in (3.81 cm)
CABLES
Two cables and a mixer adapter are used for connecting from the microphone array through
the pass-through Mounting Assembly to the mixer.
• One 4-pin mini-XLR cable is used for connecting the microphone array to the pass-through
Mounting Assembly. (Both 12-inch and 24-inch 4-pin mini-XLR drop-down cables are
provided allowing you to use the most suitable length.) A grommet is included to cover
where the cable connects to the pass-through mounting assembly.
• One 25-foot RJ45 Male to RJ45 Male CAT5e cable is used connecting at the pass-through
mounting assembly going to the mixer. If required this cable can be extended to 328Ft
(100m) using the 568B wiring standard.
• One RJ45 Male to mixer adapter is used to connect the RJ45 cable to the mixer. (There are
two types depending on which is ordered - one with 3 mini-Phoenix connectors, one with
3 XLR-M connectors.)
The microphone array is phantom powered by the mixer through the mixer adapter, the RJ45
cable and the 4-pin mini-XLR cable.