ClearOne MAX EX/MAXAttach - Manual (Page 10)

6 Technical Services: 800-283-5936
USING YOUR MAX EX PHONE
To Make a Call
1. Press the ON/OFF key. You hear a dial tone.
2. Dial the number as you would on a standard phone. The number is displayed on the LCD screen.
NOTE: You can also pre-dial the number while in standby (inactive) mode and press the ON/OFF
key to connect the call. Press and hold the pound key (#) to enter a pause in the dialing
string.
To Answer a Call
Press any key (except the star “*” key, MUTE, VOLUME UP or VOLUME DOWN) on the keypad to answer the
call.
When there is an incoming call, the phone rings and the LEDs on the phone and the phone icon on the LCD
screen flash (as shown below).
Phone active icon
To End a Call
Press the ON/OFF key. This disconnects the call and returns the phone to standby mode.
To Redial a Number
Press the ON/OFF key. You will hear a dial tone.
Press REDIAL to dial the last number called.
NOTE: You can also press REDIAL while in Standby mode to display the last number called. To
connect the call, press the ON/OFF key.
To Adjust Ringer Volume
While the phone is ringing, press VOLUME UP or VOLUME DOWN.
While the phone is inactive, press VOLUME UP or VOLUME DOWN. The ringer melody will play once at the
new level.
To Mute a Call
• Press MUTE to mute the call.
• Press MUTE again to un-mute the call.
To Make a Call Using the Phonebook
1. Press the ON/OFF key. You will hear a dial tone.
2. Press PHONEBOOK.
3. Press the number key (0-9) that corresponds with the location of the stored phone number you want to dial.
This feature must be programmed before use. See Programming Features for additional information.
1.
2.
1.
1.
2.
•
•