ClearOne SLX300 SpeakerLinX - Manual (Page 6)

2 TechSales StreamNet Design Help: 1.800.705.2103
e
thernet
C
onneCtion
The 10/100 Ethernet connector allow connection to a TCP/IP network that is setup to run StreamNet.
Using a standard (straight through) Category-5 or Category-6 Ethernet cable, connect the Ethernet
port on the SLX300 to an available port on your network router or switch.
eim C
onneCtion
(e
XpanSion
i
nterfaCe
m
oduLe
)
Using a standard (straight through) Category-5 or Category-6 Ethernet cable, connect the EIM
port on the SLX300 to any EIM compatible accessory. This includes BluePort, KeyLinX, IRLinX, any
Audio Port, or EIM enabled external amplifiers.
» NOTE: The EIM splitter is required to install a KeyLinX or IRLinX. It is shipped in the
same box with the KeyLinX and IRLinX.
S
peaker
C
onneCtionS
Connect the left/right speaker audio outputs to the intended speakers. Use the supplied 2-pin,
7.5mm screw cage connectors to adapt your cable to the output plugs. Each speaker connector
has an LED which is normally off, but turns red when the related corresponding channel experiences
a fault.
B
aLanCed
a
udio
C
onneCtionS
Balanced analog audio input and output allows for the use of longer cables while reducing
susceptibility to external noise. Use the supplied 3-pin, 3.5mm screw cage connectors to adapt
your cable to the input plugs.
The inputs allow external devices to supply audio to the SLX300 which is amplified for output on the
stereo speaker outputs. The audio is also encoded within the SLX300 for access by other devices
in the StreamNet network.
Balanced audio outputs can be used to connect to other amplifiers and audio devices.
Led i
ndiCatorS
The front panel indicator glows blue as soon as power is applied, but turns red when either channel
amplifier experiences a fault.
The balanced input has two LEDs on the back panel by the connectors, one per channel. The LEDs
are green when there is audio activity. They turn red when the input signal is too high and being
clipped.
Each speaker connector on the back panel has an LED, they are off in normal operation, turning
red if the amplifier is overloaded or otherwise has a fault.
m
onitorinG
J
aCk
The 1/4” jack on the front of the unit allows direct monitoring of the speaker outputs. This jack
provides a voltage output -21dB below that of the speaker output (open circuit) with an output
impedance of 91 ohms. This jack is suitable for listening with headphones.
p
ower
C
onneCtion
» CAUTION: To reduce the risk of electric shock, grounding of the center pin of this
plug must be maintained.