ClearOne StreamNet StarDraw Control - Manual (Page 11)

Implementation 8
After the name has been entered it will be reflected in the topology view.
Continue the process until all RC’s under the single SC are named. If there are fewer than sixteen
RC’s, the surplus can be deleted by selecting, then clicking on the Delete (red X) button.
a
dding
SC’
S and
rC’
S
If there are more than output devices in the StreamNet system, then an additional SC must be
added and then RC’s for those outputs under that. This is done by selecting the device from the
ClearOne folder, and dragging it to the topology view.
Using the tools provided in Stardraw, make the needed connections between the SC and RC’s to
the topology view.
CREATE THE UI CONTROLS
Use the Stardraw application to create the user interface controls for the software controller.
Instructions are in the Stardraw documentation located at
http://www.stardraw.com/products/
stardrawcontrol/ . Below is a sample StreamNet GUI developed using Stardraw.