Create and define the id’s for streamnet – ClearOne StreamNet StarDraw Control User Manual

Page 10

7 TechSales StreamNet Design Help: 1-800-705-2103

Select the System Comm with the mouse, then enter the IPAddress in the Properties panel at the
right of the display.

CREATE AND DEFINE THE ID’S FOR STREAMNET

The devices in the StreamNet network must be identified for use by the Stardraw controller.

yStem

omm

The System Comm (SC) device is the gateway to the StreamNet system for Stardraw. It is shown
as “StreamNet SC” in the topology view diagram. It is identified by its static IP Address, so It could
be any SpeakerLinX, MediaLinX or ControLinX in the network.

enderer

ontrollerS

There are sixteen (16) devices prefigured in the demo project, shown in the topology and named
“RC” which stands for Renderer Controller. When configured, these can be any SpeakerLinX or
ViewLinX. Each is essentially an output device.

Select each RC and enter its Name in the Properties area exactly as it is in StreamNet. You have to
name each RC and they MUST exactly match the names as assigned in StreamNet Dealer Setup.

This manual is related to the following products:

StreamNet StarDraw