ClearOne RS-232 - Manual (Page 11)

PN: 020001 4-1
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Chapter
4
Commands
This chapter discusses:

command parameters,

command sets,

sample commands, and

the unsolicited data command set.
for the PAN6400.
NOTE:
If you are using a Musica MU5066ADC in conjunction with the PAN6400,
please refer to Musica IR commands in the Musica 5066 Integration and
Design Guide (located on the NetStreams Dealer web site).
Command Parameters
The following parameter types are used in the command table below. Parameters and
are entered and returned as ASCII strings.
Table 4-1
Command Parameters
Parameter Description
Z Zone number. Range is 0-6. The 0 parameter is for all zones.
S Source. 0=Off. 1 to 4 = source.
V Volume 0-35
X Logic Level Parameter. Values are 0=Off, and 1=On. (Loudness uses the X parameter in
2.0).
D Direction to ramp. 0=down, 1=up.
P Page Group to enable/disable.
C Registered Source command
E Enable=1/Disable=0