ClearSounds TALK500 - Manual (Page 15)

14 – ENGLISH 15 – ENGLISH
Copy From The Caller ID To The Phonebook
You can copy Caller ID information to the phone book while you are reviewing
the Caller ID information.
1. Select the required Caller ID memory location by pressing or .
2. Press and hold
MENU button for two seconds, display will show COPY TO
MEMORY.
3. Press DIAL button, display will show SAVED!.
TROUBLESHOOTING GUIDE
No dial tone
1. Check that all phone cord connections (including the curly cord) and AC
Adapter are securely plugged into the telephone & wall jack.
2. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse
Setting.
3. Plug another phone into the jack to make sure your phone service is
functioning properly.
Call will not dial or dials very slowly
1. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse
Setting
No audible ringer
1. You may have too many extensions on your line. Try unplugging a few devices.
Having too many telephones /accessories can also create problems such
as low ringer volume or impaired quality during calls.
No amplification
1. Check to see if the
amplify button is “ON”. The red light should be lit.
2. Check the AC Power Adapter and make sure it is plugged into the wall and
into the appropriate jack on the phone.
Noise, Static, Interference while using the handset
1. A filter may be required for homes with DSL line or near Radio towers.
There is a red light that continues to flash
1. You have un-reviewed Caller ID / Call Waiting information or missed a call.
Caller ID information does not show
1. Make sure you are subscribed to Caller ID through your local phone
company.
No Caller ID information while on a call
1. Make sure your service provides Caller ID Information while you are on a call.
This is sometimes known as “Caller ID on Call Waiting” or “Type II Caller ID”.
2. The phone cannot display the information if another phone on the same line
is in use. Make sure all extensions are on hook.
Cannot dial out of Caller ID
1. Make sure your area code is set up properly
Talk500UserGuide.indd 15 2/4/08 5:10:24 PM