Quoizel KY5009IB Kyle - Manual (Page 3)

INSTALLATION INSTRUCTIONS
STEP 6:
a. Work the Safety Cable end through the Fixture Chain,
alternating every other link. Proceed to pass the Safety
Cable end through the Nipple, Crossbar and Outlet
Box. Make up the Tuck Washer Knot, refer to STEP 7.
Pull all of excess cable through all of the holes until the
Tuck Washer is very close to the opening at the end of
the 3/8-18 Pipe. Remove as much slack as possible out
of the Tuck Washer. About ½”of slack between Tuck
Washer and the hole is acceptable.
STYLE NUMBER: KY5009IB
3 OF 5
STEP 4:
a. Locate the Fixture Chain and attach one end of it to the
Fixture Loop at the top of the Fixture with a Quick Link
Connector.
b. Decide the length of the chain needed for your
application. You will be required to remove excess links
with bolt cutters.
STEP 5:
a. Unravel the Fixture Wires, Ground Wires and Safety Cable.
b. Pass the wires through alternating links on the chain. Proceed to pass the wires through the following
mounting components in this turn:
Canopy Lock Ring, Ceiling Canopy, Canopy Chain Loop, Lock Washer and Hex Nut, Nipple and Crossbar.
STEP 7:
a. Pull all of the Safety Cable up through the Center Hole.
b. Push the Cable down through the 12 O’clock Hole.
Leaving ½”of slack.
c. Push the Cable up through the 1 O’clock Hole and tuck
it under the cable between the Center Hole and the 12
O’clock Hole.
Fixture Chain
Quick Link
Fixture Loop
Safety Cable
Tuck Washer
Outlet Box
Structureal or
Bridging Member
12
1
Safety
Cable
12 O clock
Hole '
1 O clock Hole '
Center Hole
Tuck Washer