Quoizel AO8604MN Astoria User Manual
Fixture installation instructions

FIXTURE INSTALLATION
INSTRUCTIONS:
6 Corporate Parkway
Goose Creek, SC 29445
1. Before beginning fixture installation, carefully
unpack all parts referring to illustration for
parts identification.
2. With power to the installation OFF, locate the
UNIVERSAL CROSSBAR with GREEN
GROUND SCREW and secure to WALL
MOUNTED OUTLET BOX with (2) OUTLET
BOX SCREWS (not included).
3.
Position the FIXTURE
BACKPLATE in front of the WALL MOUNTED
OUTLET BOX and attach the HOUSE
GROUND WIRE to the FIXTURE GROUND
WIRE. Proceed to then attach both to the
UNIVERSAL CROSSBAR with GREEN
GROUND SCREW. Using wire connectors
(supplied), proceed to attach the HOUSE
WHITE WIRE to the FIXTURE WHITE
SUPPLY WIRE; connect the HOUSE BLACK
(or RED) WIRE to the FIXTURE BLACK
SUPPLY WIRE. Wrap all connections with
approved electrical tape.
4. Carefully tuck all wiring into the WALL
MOUNTED OUTLET BOX and pass the (2)
MOUNTING HOLES in the FIXTURE
BACKPLATE over the (2) MOUNTING
SCREWS attached to the UNIVERSAL
CROSSBAR. Thread (2) LOCK BALLS on
ends of screws and hand tighten to secure
fixture against wall. Make sure there are no
trapped or pinched wires.
5. Locate (1) GLASS DIFFUSER and LOCK RING.
Pass the mounting hole at top diffuser over
SOCKET. Thread LOCK RING onto SOCKET
to secure GLASS DIFFUSER. Repeat process
for remaining diffuser(s) Note: amount of GLASS
DIFFUSERS depends on style purchased.
6
7. Restore power to the installation point ON.
Retain these instructions for parts
replacement.
Make the connections:
Install the bulb(s) referring to fixture markings
and/or labels for maximum wattage.
2-light version shown
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
IS-837
3.01
FIXTURE SUPPLY
and GROUND WIRES
FIXTURE
BACKPLATE
UNIVERSAL
CROSSBAR
with GREEN
GROUND
SCREW
(2) OUTLET
BOX SCREWS
(not included)
(2) LOCK BALLS
GLASS DIFFUSER
(amount depends on
style purchased)
BULB
(not included)
LOCK RING