Exide Technologies Section 92.80 User Manual
Page 6
SECTION 1: GENERAL
1.0
General Information
SECTION 2: SAFETY MESSAGES
2.0
Sulfuric Acid Electrolyte Burns
"Warning: Risk of fire, explosion or burns. Do not disassemble,
heat above 50°C or incinerate." Batteries contain dilute (1.295
nominal specific gravity) sulfuric acid electrolyte which can
cause burns and other serious injury.
In the event of contact
with electrolyte, flush immediately and thoroughly with
water. Secure medical attention immediately.
When working with batteries, wear rubber apron and rubber
gloves. Wear safety goggles or other eye protection. These will
help prevent injury if contact is made with the electrolyte.
2.1
Explosive Gases
Hydrogen gas formation is an inherent feature of all lead acid
batteries. Absolyte GX VRLA batteries, however, significantly
reduce hydrogen formation. Tests have shown that 99% or more
of generated gases are recombined within the cell under normal
operating conditions. Under abnormal operating conditions (e.g.
charger malfunction), the safety valve may open and release
these gases through the vent. The gases can explode and
cause blindness and other serious injury.
Keep sparks, flames, and smoking materials away from the bat-
tery area and the explosive gases.
All installation tools should be adequately insulated to minimize
the possibility of shorting across connections.
Never lay tools or other metallic objects on modules as shorting,
explosions and personal injury may result.
2.2
Electrical Shock and Burns
Multi-cell systems attain high voltages, therefore, extreme cau-
tion must be exercised during installation of a battery system to
prevent serious electrical burns or shock.
Interrupt the AC and DC circuits before working on batteries or
charging equipment.
Ensure that personnel understand the risk of working with bat-
teries, and are prepared and equipped to take the necessary
safety precautions. These installation and operating instructions
should be understood and followed. Assure that you have the
necessary equipment for the work, including insulated tools, rub-
ber gloves, rubber aprons, safety goggles and face protection
2.2.1 Static Discharge Precautions for Batteries
When maintaining a connected battery string, care must be
taken
to
prevent
build-up
of
static
charge.
This
danger
is
particularly
significant
when
the
worker
is
electrically isolated, i.e. working on a rubber mat or an epoxy
painted floor or wearing rubber shoes.
Prior to making contact with the cell, discharge static electricity
by touching a grounded surface.
Wearing a ground strap while working on a connected battery
string is not recommended.
2.3
Safety Alert
2.4
Important Message
SECTION 3: DELIVERY INFORMATION
3.0
Receipt of Shipment
Immediately upon delivery, examine packaging for possible
damage caused in transit. Damaged packing material or
staining from leaking electrolyte could indicate rough han-
dling. Make a descriptive notation on the delivery receipt
before signing. If cell or unit damage is found, request an
inspection by the carrier and file a damage claim.
CAUTION!
Before proceeding with the unpacking, handling, instal-
lation and operation of this sealed lead-acid storage
battery, the following information should be reviewed
thoroughly. The safety procedures should be strictly
adhered to when working with Absolyte GX batteries.
DANGER!
SULFURIC ACID ELECTROLYTE
BURNS
DANGER!
EXPLOSIVE GASES
CAUTION!
If the foregoing precautions are not fully understood, clarifica-
tion should be obtained from your nearest GNB representa-
tive. Local conditions may introduce situations not covered by
GNB Safety Precautions. If so, contact the nearest GNB rep-
resentative for guidance with your particular safety problem;
also refer to applicable federal, state and local regulations as
well as industry standards.
The safety alert symbol on the left appears
througout this manual. Where the symbol
appears, obey the safety message to avoid
personal injury.
The symbol on the left indicates an impor-
tant message. If not followed, damage to
and/or impaired performance of the battery
may result.
6
DANGER!
ELECTRICAL SHOCK AND BURNS
HIGH VOLTAGE…
RISK OF SHOCK.
DO NOT TOUCH
UNINSULATED
TERMINALS OR
CONNECTORS.