Printer operation, Mode settings [datamax, Emulation – CITIZEN CL-S700R User Manual
Page 46
2
Printer Operation
46
Top Menu
Sub Menu
Default
Menu
Remarks
Network Address
0.0.0.0
0.0.0.0 to
Setting fixed IP address of the LAN board.
255.255.255.255
Subnet Mask
0.0.0.0
0.0.0.0 to
Setting fixed subnet mask value of the LAN
255.255.255.255
board.
Gateway address
0.0.0.0
0.0.0.0 to
Setting fixed default gateway address of the
255.255.255.255
LAN board.
BOOTP
Off
On
Setting the BOOTP of the LAN board.
Off
DHCP
Off
On
Setting the DHCP of the LAN board.
Off
USB Device Class
Printer
Printer
Selects the USB device class.
[USB Device Clas]
VCOM
USB VCOM Protocol
Auto
Auto
Selects the protocol (flow control) when
[VCOM Protocol]
DTR
operating USB VCOM.
X-ON
Machine
Model Number
–
CL-S***
Displays the model name.
Information
Boot Version
–
*.*
Displays the boot version.
[Machine Info]
ROM Version
–
********
Displays the ROM version.
ROM Date
–
**/**/**
Displays the date the ROM was prepared.
ROM CheckSum
–
****
Displays the check sum of the ROM.
Head Check
–
OK
Displays the results of the head check.
NG
Print Counter
–
****.*** km
Displays the print counter.
Service Counter
–
****.*** km
Displays the service counter.
Cut Counter
–
–
Displays the cut count.
Sensor Monitor
–
*.* V
Displays the sensor level.
Option Interface
–
None
Displays the presence/absence of the
[Option I/F]
LAN
optional interface.
Test Mode
Print Pattern
Current Config
Current Config
Executes the test pattern.
Global Config
Sample
Head Check
No
Yes
Executes head check.
No
Factory Default
No
Yes
Initializes the set values of the configuration
No
set to the state when the unit was shipped
from the factory.
Hex Dump
No
Yes
Sets the hex dump mode.
No
Serial Monitor
–
–
Displays the state of the serial interface.
Auto Calibration
See Through
See Through
Executes the calibration of the sensor.
[Auto Cal]
Reflect
Sensor Monitor
See Through
See Through
Displays the level of the sensor.
Reflect
Global
–
Config Set 1
Config Set 1
Sets the Config Set.
configuration
Config Set 2
[Global Config]
Config Set 3
Mode Settings
[Datamax
®
Emulation]
Note:
To restore factory default settings, turn on printer power while pushing the MENU and PAUSE keys
simultaneously, then press the FEED key and the STOP key sequentially.