Paring, Pairing the wi audiolink – Wi Digital Systems Wi-AudioLink User Guide User Manual
Page 19
Pairing the Wi AudioLink!
Before using the Wi AudioLink with your instruments, you need to pair the transmitter with the receiver.
Pairing will create a connection between the transmitter and receiver.
1.
First turn ON the transmitter (Tx) and the receiver (Rx) by pressing and
holding the POWER button , on each of the units for 2 seconds.
2.
Press and hold the LINK button on the transmitter (Tx) for 3 seconds.
The Power/Status LED on the transmitter will start flashing. The transmitter
is now in a Pairing mode and ready to search for receivers.
3.
Press and hold the LINK button on the receiver (Rx) for 3 seconds.
The Power/Status LED on the receiver will start flashing. The receiver
is now in a Pairing mode and ready to be found by the transmitter.
4.
Once the transmitter pairs with receiver, the Power/Status LED on both
devices will turn to solid Green.
5.
The Wi AudioStream transmitter and receiver are now ready for use.
PARING
Wi AudioLink
19
p
k
(Tx)
p
k
z
v
z
v
(Rx)