Waring CB15VSF - Manual (Page 12)

12
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE
FOLLOWING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft,
or shaft seals. These parts are lubricated and
sealed at the factory and do not require any further
lubrication.
2. Reduce amounts of material processed to less than
the full 4-liter capacity when working with viscous or
fibrous materials.
3. When cleaning exterior of container, keep it in normal
upright operating position to prevent liquids from
running into the bearing through the bottom end.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot
materials, the following precautions and procedures must be
observed:
• Hot materials are those which are 100˚F (38˚C) or hotter.
• Always start blending on lowest speed setting, then
progress to desired speed.
• Never stand directly over blender when it is being started
or while it is running.
• Constant monitoring of the condition of the container lid
gasket and the container lid clamps is mandatory. Replace
these parts if they become worn or loose, or are damaged
in any way.