Waring 7015N - Manual

B
lender
O
perating
M
anual
IMPORTANT
HOT BLENDING INSTRUCTIONS
To minimize the possibility of scalding when blending hot materials, the
following precautions and procedures must be observed:
1) If you are using the standard two-piece container lid that originally
came with your blender, limit the amount of material processed to
1/2 pint.
NOTE: A special accessory lid assembly is available for use with
stainless steel containers only, which allows safe processing of
larger loads.
Order 1-Quart Hot Blending Lid, Catalog No. CAC14.
2) If you are using the standard two-piece container lid, completely
remove the center portion of the lid before turning blender on.This
will allow venting of the rapidly heated and expanding air present
inside container when blender is running.
If you are using the special accessory lid, follow the instructions
packed with the lid; venting will be accomplished automatically.
3) Always start blending on lowest speed setting, then progress to
desire speed.
4) Never stand directly over blender when it is being started or while
running.
SERVICE
Refer to the list of Factory Approved Service Centers enclosed with
your Waring Blender for the name of the nearest Service Center or
Write to:
SERVICE CENTER
314 ELLA T. GRASSO AVENUE
TORRINGTON, CT 06790
(800) 269-6640
Ship Blenders for repair to the above address or to a Factory Approved
Service Center. Do not ship to a Waring Sales Office.
Replacement parts for your own “Out of Warranty” repairs are obtainable
at the above address.
WARING COMMERCIAL
314 Ella T. Grasso Ave.
P.O.Box 3201
Torrington, CT 06790
www.waringproducts.com 014775 RV05 0306