Unitec CAME Wiring User Manual
Page 17
Document
Number:
GC1004
13
Document Title:
Unitec CAME Gate and Gate Controller Installation Guide
Depending on the interface of your WSII to the tunnel controller, you may need to put the WSII into
“Attended Tunnel Mode”
When the Tunnel Mode is set to “Attended,” each customer will receive a receipt to give to the
attendant, who will then arm the appropriate wash. For an interface to a Gate controller, you should
either use Roll Over or Attended mode. Do not use Mode 1 - Unattended mode.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in setup
mode by moving the switch toward the back of the Wash Select II case. (The CPU board is
located on the inside right wall of the Wash Select II case.)
2. On the WSII keypad, use the (3) key to scroll forward and the (1) key to scroll back. Scroll
through the main menu until the “Wash Interface” option is displayed. Press the (*) key to
enter.
3. Scroll through this menu until the “Tunnel Mode” option is displayed, and then press the (*)
key to enter.
4. Press the (2) button for “Attended Tunnel Mode” or (0) button to disable tunnel mode and
then press the (*) key.