2pc15cp controller operation – Trebor PC15CP User Manual
Page 5
PC15CP PUMP CONTROLLER OPERATION / MAINTENANCE MANUAL
PAGE 5
2
PC15CP CONTROLLER OPERATION
The controller is operated by using the buttons located on the PLC, see Table 2-1.
Table 2-1: PLC Buttons
Button
Action from “Home Page”
Action from “Menu Pages”
Scroll through Menu pages
Go to Home page
Enables/Disables controller
cycling
Navigate between Menu pages
Increases pump cycle rate on
Home page
Increase values
Decreases pump cycle rate on
Home page
Decrease values
2.1 TURNING PUMP ON AND OFF
From the Home Page, pressing the RIGHT arrow key () will start and stop the
cycling of the pump controller. When cycling, a cursor will oscillate under positions
“1” & “2”.
Figure 3: Controller Cycling
2.2 ADJUSTING CONTROLLER
2.2.a Suggested Controller Values
Flow Rate
CPM
Air Flow Control
Overlap
- 0-4 LPM:
“000030”
“3” Turns from closed
20
- 3-6 LPM:
“000056”
“2” Turns from closed
10
Please contact Trebor Service Group for any updates on these settings.
2.2.b Cycle Rate
From the Home Page, press the LEFT arrow key (
) to open the Cycle Rate. From there
the cycle rate can be adjusted by pressing the UP (
) and DOWN (
) arrows.