Trail Master Suspension TM102N GM 1500 4WD/2WD SUSPENSION 4 LIFT KIT - Manual (Page 11)

11
TM102N
Revised
2.4.14
23. Be sure to use thread locker and torque the
sway bar hardware according to manufactur-
ers specifications.
24. Repeat steps on the remaining side of the ve-
hicle.
25. Install the new skid plate (82-9144) to the
front and rear crossmember using the (3)
10mm X 30mm bolts and hardware. Be sure
to use thread locker and torque to
45 ft./lbs.
26. Grease the upper control arm ball joints.
NOTE: It’s a good idea to grease the ball
joints every time you change the oil.
27. Install the front wheels and lower the vehicle
to the ground. Torque the lug nuts according
to the wheel manufacturers recommendations.
28. Recheck all hardware for proper installation
and torque at this time.
IMPORTANT! BE SURE TO BRING
THE VEHICLE IMMEDIATELY TO A REPU-
TABLE ALIGNMENT SHOP TO BE
ALIGNED! OE Sway Bar
End Link
Hardware
OE Sway
Bar End
Link
OE Sway
Bar
OE Lower
Control arm
OE Skid
Plate Bolt
OE Skid Plate Bolt
82-9144
Lower Skid
Plate