TDK TP6803 3 Speaker Boombox - Manual (Page 8)

8
AC CONNECTION
Insert the end of the power cord into the adapter, and then insert the small end of
the AC adapter into the DC IN jack on the rear of the unit. Insert the other end (with
the 2 blades) into a conveniently located AC outlet having 120V, 60Hz.
AC ADAPTER SPECIFICATIONS: DC 24V Z
NOTES:
• To disconnect the AC adapter, remove it from the DC IN jack of the unit as well
as from the AC outlet.
• Use the enclosed AC adapter for this product only.
INSERTING BATTERIES
To use this unit with battery power,
remove the Battery Compartment
cover on the rear of the unit by
removing the three screws with
a flathead screwdriver, and then
lifting the cover off. Insert twelve (12) “D” cell batteries (not included), observing
the battery polarity indicated inside the compartment. Replace the Battery
Compartment cover and screws.
NOTE: The AC adapter must be disconnected from the jack on the rear of the
unit in order for the unit to operate on battery power. We recommend Alkaline
or rechargeable types for maximum cycle time or ecological efficiency.
POWER SOURCES
AC Plug
AC Outlet
+ – + – + –
+ – + – + –
+ – + – + –
+ – + – + –
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Caution – Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery
Compartment. A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc)
or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufacturer’s directions.)
7. Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.