TDK TP6802 2-Speaker Boombox - Manual (Page 8)

8
AC CONNECTION
Insert the small end of the AC adapter into the jack on the
rear of the unit. Insert the other end (with the 2 blades) into
a conveniently located AC outlet having 120V AC, 60Hz.
AC ADAPTER SPECIFICATIONS: DC 18V
NOTES:
• To disconnect the AC adapter, remove it from the DC IN
jack on the side of the unit as well as from the AC outlet.
• Use the enclosed AC adapter for this product only.
INSERTING BATTERIES
To use this unit with battery power,
remove the Battery Compartment cover
on the rear of the unit by removing the
three screws with a flathead screwdriver,
and then lifting the cover off. Insert ten
(10) “D” cell batteries (not included),
observing the battery polarity indicated
inside the compartment. Replace the
Battery Compartment cover and screws.
NOTE: The AC adapter must be disconnected from the jack on the rear of the
unit in order for the unit to operate on battery power. We recommend Alkaline or
rechargeable types for maximum cycle time and ecological efficiency.
STRAP
For ease of carrying, simply slide each strap end into
the strap holder on each side of this unit until it clicks
in place, as shown. Then, press the male buckle to
release the strap.
INSTALLATION
AC Outlet
AC Adapter’s Plug
To DC 18V In Jack
+ – + – + – + – + –
+ – + – + – + – + –
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Caution – Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery
Compartment. A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc)
or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufacturer’s directions.)
7. Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.
PRESS THIS BUTTON