Stealth Cam STC-IR1 - Manual (Page 24)

STC-IR1
www.stealthcam.net Toll Free 877-269-8490
24
Using the camera in PIR detection mode
o Mount the camera to tree or other sturdy object using either the
supplied tree screw or mounting strap (Please refer to the
Mounting Suggestions section in this manual).
o Open the front housing & move the switch to the ON position. At
this point you have 30 seconds to make any program
adjustments.
o After 30 seconds the camera's green test light will begin
blinking.
This is your indication to leave the coverage area within one minute.
o After one minute the camera will be in Detection mode.
o Based on your program the camera will take between 1-3
pictures or a 10 second AVI video. The camera will then time
out between 1 - 60 minutes also based on your setting.
Note: The time between motion detection and the camera taking
pictures may vary due to lighting conditions, program
setting and battery power level.
o The IR lighting will only activate in low light conditions. (Below