Stealth Cam STC-IR1 - Manual (Page 23)

STC-IR1
www.stealthcam.net Toll Free 877-269-8490
23
o When you have completed the testing the coverage area there
are 2 methods for exiting test mode:
1. Open the front housing and press the TEST button to
exit test mode. The camera will then enter sleep mode
for 1 minute. After one minute the camera will power up
and LCD screen will turn on. At this point you have 45
seconds to make any last minute adjustments. After the
45 seconds the green LED indicator will start blinking
giving you one minute to leave the coverage area. The
camera then enters PIR detection mode.
2. After 5 minutes in TEST mode, the camera will then
enter sleep mode for 1 minute. After one minute the
camera will power up and LCD screen will turn on. At
this point you have 45 seconds to make any last minute
adjustments. After the 45 seconds the green LED
indicator will start blinking giving you one minute to
leave the coverage area. The camera then enters PIR
detection mode.