Part vii : configure the hand control – Sky-Watcher SynScan V3 Hand Controller User Manual
Page 27
27
PART VII : CONFIGURE THE HAND CONTROL
7.1 Display, Keypad, and Beeper
7.2 Alignment Star Filter
7.3 Sorting Method of the Alignment Star List
1.
Access the menu “
Setup \ Handset Setting
” and press the
ENTER
key.
2.
Use the scroll keys to select “
LCD Contrast
”; then use the left/right direction keys to adjust
the contrast of the LCD screen.
3.
Use the scroll keys to select “
Beep Volume
”; then use the left/right direction keys to adjust
the volume of the beeper.
4.
Use the scroll keys to select “
LED Backlight
”; then use the left/right direction keys to adjust
the brightness of the keypad’s LED backlight.
5.
Use the scroll keys to select “
LCD Backlight
”; then use the left/right direction keys to adjust
the brightness of the LCD screen’s backlight.
6.
Press
ESC
to exit the adjustment.
1.
Access the menu “
Setup \ Alignment Stars \ Sort by
” and press the
ENTER
key.
2.
Use the scroll keys to select “
Magnitude
” and press the
ENTER
key to sort the list by mag-
nitude (from the brightest to the faintest).
3.
Use the scroll keys to select “
Alphabet
” and the press the
ENTER
key to sort the list alpha-
betically.
• The alignment star’s altitude must be above 15 degrees.
• For an equatorial mount, the alignment star’s declination must be between -75 and +75
degrees.
• For an alt-azimuth mount, the alignment star’s altitude must be below 75 degrees or within
the altitude limits defined by the user
(Section 6.3)
.
Not all combinations of alignment stars are good for a 2-star alignment or 3-star alignment.
The SynScan hand control uses a built-in advanced alignment star filter to show only the stars
which is suitable to work with the 1
st
or 2
nd
alignment star(s), when asking the user to choose
the 2
nd
or 3
rd
alignment star. It helps to improve the success rate of the alignment.
Some advanced users or those who have limited visible sky can turn on/off this advance filter
with the following steps:
1.
Access the menu “
Setup \ Alignment Stars \ Adv. Filter
” and press the
ENTER
key.
2.
Use the scroll keys to choose “
OFF
” and then press the
ENTER
key to disable the filter.
3.
Use the scroll keys to choose “
ON
” and then press the
ENTER
key to enable the filter.
Note: Even if the advanced filter function is turned off, the SynScan hand control will still apply
the following rules to generate the list of alignment stars: